Reviewing PKS logs and status

After a bit of a sabbatical, I am back to looking PKS (Pivotal Container Service) again. I wanted to look at the new version 1.3, but I had to do a bit of work on my environment to allow me to do this. Primarily, I needed to upgrade my NSX-T environment from version 2.1 to 2.3. I followed this blog post from vmtechie which provides a useful step-by-step guide. Kudos to our VMware NSX-T team as the upgrade worked without a hitch. My next step was to start work on the PKS deployment. I just did a brand new deployment…

Integrating NSX-T and Pivotal Container Services (PKS)

If you’ve been following along my recent blog posts, you’ll have seen that I have been spending some time ramping up on NSX-T and Pivotal Container Services (PKS). My long term goal was to see how these two products integrate together and to figure out the various moving parts. As I was very unfamiliar with both products, I took a piece-meal approach to both. First, I tried to get some familiarity with NSX-T. You can find my previous posts on NSX-T here: Building a simple ESXi host overlay network with NSX-T First steps with NSX-T Edge – DHCP Server Next…

Next steps with NSX-T Edge – Routing and BGP

If you’ve been following along on my NSX-T adventures, you’ll be aware that at this point we have our overlay network deployed, and our NSX-T edge has been setup to with DHCP servers attached to my logical switch, which in turn provides IP addresses to my virtual machines. This is all fine and well, but I’d also like these VMs to reach the outside world. NSX-T enables this through a feature called logical routers. In this post, I will talk you through how to configure a tier 0 logical router which connects to the outside world, a tier 1 logical router…

First Steps with NSX-T Edge – DHCP server

Now that we have an overlay network deployed, its time to turn our attention to the NSX-T Edge, and get it to do something useful for us. A NSX-T Edge can do many useful things for you (Routing, NAT’ing, etc). But I really want to keep things as simple as possible, so I will deploy my NSX-T Edge to provide DHCP addresses to my VMs. In order to do this, my Edge will first of all need to participate in the same overlay/tunnel network as my hosts. I will then need to create a logical switch that my VMs can…